Stump Removal in Georgian Bay: What Homeowners Should Know Before Getting Started

Driveway Permit Tiny: A Practical Homeowner’s Guide to Entrance Permits in Tiny Township

If you’re planning to build a driveway, widen an existing one, replace a culvert, or clear a vacant lot in Tiny Township, you’re going to encounter something called an Entrance Permit. Most locals simply call it a driveway permit. This guide explains, in plain language, when you need a driveway permit in Tiny, what it costs, how to apply, what inspectors look for, and the common mistakes that hold up projects.

What is a Driveway (Entrance) Permit and Why is it Required?

In Tiny Township, the first several feet from the road edge onto your property fall inside the municipal road allowance. This is where the drainage ditch, culvert, and roadway shoulder are located. When you build or modify a driveway, you’re affecting Township property—not just your own land.

The Township requires a driveway permit to ensure:

  • Drainage continues to flow properly through roadside ditches
  • The driveway tie-in does not interfere with snowplow blades
  • Vehicles entering and exiting have safe visibility
  • Culvert size and slope prevent erosion and flooding

Done right, the entrance works with the road, not against it. Done wrong, it causes drainage failures, plow damage, roadway icing hazards, and blocked sightlines.

When You Need a Driveway Permit in Tiny Township

You need a permit if you are doing any of the following on a Township road:

  • Installing a brand-new driveway entrance
  • Clearing a vacant lot for the first time (equipment needs legal access)
  • Widening, shifting, or redesigning an existing driveway
  • Paving the driveway apron at the road edge
  • Installing or replacing a culvert

Important: You generally cannot clear trees or bring heavy equipment onto a vacant lot until a temporary or permanent entrance permit has been approved. The entrance comes first.

Types of Driveway / Entrance Permits in Tiny

Temporary Entrance Permit

This is used when you want to clear a vacant lot or bring in fill before you have finalized building plans. No lot grading plan is required for this permit. It is typically valid for one year and will eventually need to be upgraded to a permanent entrance.

Permanent Entrance Permit

This is used when you are building the final driveway. A lot grading plan prepared by your designer/engineer is required. The Township inspects the final entrance to confirm that slopes and drainage match the approved plan.

Change of Design / Relocation Permit

Used when you’re widening or shifting an existing driveway. A simple sketch is usually enough unless significant regrading is involved.

Paving or Culvert Replacement Permit

Required when paving or replacing the culvert within the road allowance. The permit itself is typically $0, but you are responsible for supplying and installing the culvert to Township standards.

Driveway Permit Costs in Tiny Township

  • $230 — Temporary Entrance Permit
  • $230 — Permanent Entrance Permit
  • $150 — Change in Design / Location Permit
  • $0 — Paving / Culvert Replacement Permit (installation costs still apply)

If you need a new civic address sign, add approximately $80.

What the Inspector Looks For

The Township inspector assesses:

  • If a culvert is required, and what diameter
  • Driveway entrance width and slope at the tie-in
  • Proper drainage through the ditch (no blockages or pooling)
  • Safe sightlines when entering/exiting
Builder Tip: Although the minimum culvert diameter is sometimes listed as 300 mm (12″), in practice Tiny inspectors often specify 400 mm (15″) HDPE culverts due to seasonal melt and stormwater flows.

Timeline: How Long Approval Takes

Once the application is submitted and the entrance location is staked on site, the Township review typically takes up to two weeks. Busy seasons may take a bit longer. After the work is completed, you must call for a final inspection to close the permit.

Common Mistakes That Cause Delays

  • Not staking the entrance before the Township inspection
  • Buying the wrong culvert size before approval
  • Paving before the base has settled and slopes confirmed
  • Placing the entrance in a poor sightline area (curves, hills, tree lines)
  • Allowing the permit to expire without calling for final inspection

Choosing the Best Entrance Location

If your property is long along the road, take time to choose the entrance location carefully. Factors to consider:

  • Elevation and drainage
  • Existing trees and root systems
  • Driveway slope and winter traction
  • Visibility in both directions

A small shift of 10–20 feet can sometimes turn a difficult driveway into a smooth one.

Final Thoughts

Getting a driveway permit in Tiny Township is a straightforward process when you understand what the Township is looking for: good drainage, safe access, and a clean tie-in to the road. Handle the entrance early, confirm culvert size before buying materials, and always call for the final inspection before the permit expires.

Leave a Reply

Your email address will not be published. Required fields are marked *